不锈钢加工（Stainless steel processing）.docVIP

不锈钢加工（Stainless steel processing） I fully agree with the above statement. Stainless steel processing, mainly has the following difficulties: First, when processing, the workpiece and the tool heat quantity is high, the tool is easy to wear off. Therefore, the tool has a certain requirement, wear resistance, high temperature. At the same time, to achieve sharp blade, choose a reasonable angle. Two, the speed is slow, the stress is greater when cutting. The production efficiency is not high. Three, high calorific value, cooling oil selection is very important, usually with sulfur chloride. Better effect. Four, drilling holes and tapping, the most difficult. (personal feelings) Five, processing stainless steel, workers must have some experience and excellent technology. The processing properties of 1 stainless steel, stainless steel cutting plastic, high toughness, cutting the consumption of energy, high cutting temperature of stainless steel; low heat conductivity, heat is not easy to form high temperature stainless steel welding tool; coagulation bonding is strong, bue is easily formed in the cutting process; stainless steel processing hardening tendency, cutting surface the formation of hardened layer; stainless steel is easy to break the chip, easy to plug in the cutting process, the effect of processing the surface finish. 2 stainless steel cutting tool rake angle, rake angle can not be too large, generally 12--30 degrees; the front, front grinding crescent chip guiding groove can improve the cutting conditions; after the angle of cemented carbide tool, after the angle should be 6--10 degrees, the high-speed steel tool, after the angle is 8--12 degrees; the main angle. The main angle of 60--75 degrees; auxiliary angle, should be 8--20 degrees; in the rough car should be greater than zero, the fine car should be less than zero; tip radius, is generally 0.2--0.8mm. 3 stainless steel cutting in the cooling lubrication: the use of cooling and lubricating properties of