svg（SVG）.docVIP

svg（SVG） Static var generator (SVG) -- a brief introduction to the principle of Static var generator (SVG) is a device that uses the full bridge converter controlled power electronic devices consisting of dynamic reactive power compensation. The thought of SVG as early as 1970s has been proposed, in 1980 Japan developed 20MVA using force commutated thyristor bridge circuit of SVG in 1991 and 1994, Japan and the United States were successfully developed 80MVA and 10OMVA by GTO thyristor SVG. The research on SVG and its application in power industry or real interests is just unfolding, domestic related research has been reported. Compared with the traditional represented by TCR SVC SVG, adjust the speed faster, wide operation range, and the compensation current harmonic content is greatly reduced by adopting multiple or PWM technology measures. More importantly, the use of SVG reactor and capacitor components than the use of SVC in the reactor and capacitor should be small, it will greatly reduce the volume and cost of the device. Because SVG has such superior performance, is an important direction for the future development of dynamic reactive power compensation device. The basic principle and characteristics of SVG The basic principle of SVG is the bridge converter circuit through the reactor parallel (or direct parallel) in power grid, the phase and amplitude adjusting bridge converter AC side output voltage or directly control the AC side current, cause the circuit to absorb or deliver required reactive current, so as to realize the dynamic reactive power compensation objective. In single-phase circuit, and reactive power is the energy back and forth between the power source and the load. But in three-phase circuit balance, regardless of the load power factor, three-phase instantaneous power and is certain, is equal to the total active power three-phase at any moment. On the whole, between the power supply circuit and three-phase load reactive energy tromboning, r