施工工序方案（The construction process scheme）.docVIP

施工工序方案（The construction process scheme） The construction process of Views: 1967 reward points: 0 | question time: 2009-10-12 10:33 | questionger: 815292164 What are the construction procedures in civil engineering? Recommendation one, construction according to 1, design and construction drawings 2, masonry construction quality acceptance specification 3, masonry engineering construction operation regulations Two, the construction requirements (a) material requirements 1, the construction unit of the construction materials of cement, clay brick, clay brick, clay brick, high hole aerated concrete block masonry, must carry out inspection and approval procedures, supervision company checks, prohibited unqualified materials into the construction site. 2, aerated concrete block is cement gel strength to 28 days as the standard of design strength reinforced bulk, and before the age of 28 days did not reach the bulk itself, shrink rapidly. In order to avoid shrinkage cracks and ensure the quality of masonry, the aerated concrete block must reach 28 days old. (two) masonry requirements 1. The foundation walls in contact with the soil must be made of clay solid bricks. No clay big hole brick or clay porous brick shall be strictly prohibited. 2, in accordance with the requirements of the mandatory provisions of the Ministry of construction, the bathroom wall must be cast height greater than 200mm, more than C20 concrete label on the ridge. 3, other parts of infilled masonry wall, the bottom should be building height of more than 200mm of clay solid brick or precast concrete block. 4, fill masonry wall, clay hollow brick brick hole should ensure that the level of porous clay brick masonry, brick masonry should ensure the vertical hole; clay brick, clay brick, clay brick masonry in the big hole must use the day before the water soaked, aerated concrete block suitable amount of water in the surface of masonry masonry. 5, infilled masonry mortar must be strictly in accordance with