高层建筑结构转换层施工技术的运用（Application of construction technology of structural transfer floor in high rise building）.docVIP

高层建筑结构转换层施工技术的运用（Application of construction technology of structural transfer floor in high rise building） Application of construction technology of structural transfer floor in high rise building At present, the development of the high-rise building more and more quickly, combining with the project examples, from the aspects of the high-rise building structural transfer floor construction of formwork supporting system design and calculation, installation and reinforcement of large volume concrete are described and difficulties in the construction of the transformation of the structure, and the key points of construction quality control measures a detailed discussion. 1. General situation of Engineering Three phase of a city 15# building, 27 floors on the ground, with a total construction area of 27216m2, frame shear wall structure, the standard height of 3.0m. The structure transfer storey is made of reinforced concrete frame structure on the third floor and below the 3 floor, and the shear wall structure is above three storeys. The design level of transition layer girder concrete is C55, and the maximum transition beam cross section size is 1100mm * 1800mm, and the floor thickness is 250mm. 2, construction transfer layer construction technology and quality control measures Reinforcement, reinforced connection and binding, concrete pouring and crack control for formwork support is the key point of the engineering construction of transition layer and difficult, and this is the current research focus and difficulty of building construction personnel. The construction process of transfer floor is shown in figure 1: 2.1 formwork support system design The support system can be made of 48 steel pipe or door type. To the board bottom support, according to the vertical pole spacing not more than 1 m request erection, generally may guarantee the security. For the support at the bottom of the beam, the bearing capacity must be checked because of the large construction load.