架立筋和通长筋（Erect steel and long tendons）.docVIP

架立筋和通长筋（Erect steel and long tendons） What is clear to erect steel and reinforced through the real meaning? Should first understand the specific meaning of stirrups, because the reinforced concrete beam to a stirrup. A stirrup, without any other things put it up, it is helpless. In general, the upper part of the beam is provided with a negative tendon, whether it is stressed or constructed. According to the force or structure, the beam is provided with a double limb hoop or a limb hoop. If it is the limbs hoop, up and down, there will be four corners. If four points are not allowed, the upper and lower beams must be provided with four reinforcing bars. In the case of a frame beam, both ends of the beam are stressed steel bars, and in theory, the beam is in the middle 1 / 3 section without force or only a small force. Then, the section above the beam should not be fitted with longitudinal reinforcement. However, the above said, stirrups can not be empty, we have to set the number of stirrups and stirrups corresponding to the structure of steel, these structural reinforcement, diameter smaller than the force of steel, we call them the erection of tendons. Above the shelf stud, may contain so-called long steel. Long steel frame beam is mainly used for seismic design of the frame structure in the design staff that need continuous beam or non frame structure in the long steel set. In the seismic design, the number of long steel beams, according to the specific force, more or less, sometimes the upper bar are connected. When the number of steel number less than upper limb long stirrups, is used to fill the bar diameter smaller corner stirrups empty up. Long steel is always placed on the outside of the bearing bar in the middle. The bar and the rest of the steel bars on each end overlap each other, and the lap length, except for special requirements, is generally 150 - 250. The through bar is the force bar of the beam, it is pressed in the middle of the beam and bears the