电气通用设备（Electrical general equipment）.docVIP

电气通用设备（Electrical general equipment） Preventive maintenance specification of main mechanical and electrical equipment (General Electric) Preventive, mechanical and electrical equipment, electrical preventive, electrical, mechanical and electrical equipment, maintenance, specification 1, general provisions 1) parts complete, to meet the requirements of the technical performance requirements. The replacement of parts, its technical performance shall not be lower than the original design requirements; 2) explosion-proof enclosures or flameproof surface, must be embalmed. Processing method: equipment shell can be sprayed or coated with anticorrosive paint; explosion-proof surface chemical treatment or regular processing can be coated with anticorrosive oil; junction box inner wall and the inner wall of the metal casing may have a normal part of the spark, must be evenly coated with arc resistant paint; 3) maintenance of electrical equipment, in addition to the provisions of the factory test, and should be according to the relevant provisions of the electricity test. Electricity test time is generally less than 2h; 4) equipment maintenance should be a nameplate, such as nameplate data change or illegible, should be replaced with new nameplate. 5) protection plug-in installation, to prevent loosening of the device is complete and effective; 6) shall fill out the records, test records, maintenance records for the determination of the quality of spare parts maintenance, overhaul equipment, must be approved by the Department of transportation and acceptance, can be put into use. 2, the provisions of fasteners 1) fastener material should be applied to housing material; 2) with the bolt, nut and washer etc. should be treated with spraying anticorrosive paint, plating or other chemical methods, to prevent corrosion; 3) bolt and nut fastening to prevent loosening measures. According to the specific requirements of equipment parts, by adding a spring washer and a back cap or pin.