钢化玻璃标准（Tempered glass standard）.docVIP

钢化玻璃标准（Tempered glass standard） Standard for inspection of tempered glass 1. performance requirements 1.1 with low iron tempered glass suede (also known as Bai Boli), in the wavelength range of the solar cell spectral response (320-1100nm) in the light transmission rate of more than 91%, the reflectivity is higher for the more than 1200 nm infrared light. The glass can resist the radiation of sunlight and ultraviolet light at the same time, and the transmittance is not decreased. (NM nm) 1.2 glass passes or conforms to national standards GB/T 9963-1998 and GB 2828-87. 2. quality requirements and inspection methods 2.1 thickness The thickness is 3.2mm, and the allowable deviation is + 0.2mm. 2.2 size The allowable deviation of the length of 2.2.1 rectangular glass shall comply with the provisions of table 1. Table 1 side tolerance of rectangular tempered glass, unit mm Thickness side length (L) allowable deviation L = L L 3000 3000 L 3, 4, 5, 6, +1 -2 + 3 + 4 + 5 8, 10, 12, +2 -3 The diagonal deviation of the 2.2.2 rectangular glass shall comply with the provisions of table 2. Table 2 the allowable value of diagonal difference for rectangular tempered glass is mm Allowable value of thickness diagonal difference The length is less than or equal to L 3000 3000 L 3, 4, 5, 6 + 3 + 4 + 5 2.3 burst edge inspection The length of the length of each piece of glass is not more than 10mm, extending from the glass edge to the glass surface, the depth is not more than 2mm, the thickness of the plate facing the glass, the extension depth is not more than 1/3 of the thickness of the 1 edge of the explosion. Avalanche requirement: As shown in the following figure. 2.4 bubble test Round bubble requirements: L = 0.5mm 0.5mm L 1mm account, allowing 3 * S. Requirements for long bubbles: Width = 0.5mm, L = 1.5mm. The width is more than 0.5mm, L less than 1.5mm is allowed to have 3 x S. 2.5 inclusions, stones L = 0.5mm at 0.5mm = L = 1mm, allowing 2 * S