安全网搭设（Safety net erection）.docVIP

安全网搭设（Safety net erection） This project uses the fastener type steel pipe scaffold, according to the project practical need, establishes the double row scaffold, forms along the East and West both sides exterior wall to form the scaffold system, the scaffold shape changes with the building shape change. The operation layer is full of feet. Scaffold row distance 1.50M, scaffolding side vertical pole outside the outer wall, retaining wall 0.40m. 1. pole erection, rod spacing of about 1.50M, because of the shape and purpose of the building, vertical spacing can be slightly adjusted, vertical row row spacing 1.50m. In between the rows of pole and wall spacing 0.40m, vertical rod and the outer wall spacing 1.90m, frame body with double pole, single upper pole. The adjacent vertical rod joint should be staggered from 2 to 3m, and must be connected with a single fastener. No cross fastener can be used on the big cross bar or lapped with a rotating shaft fastener. The vertical pole must be vertical, allowing the deviation 1/200 vertical pole height. Inside and outside the row of two rod and the wall perpendicular to the connection. Scaffolding to the top of a building, in the bar below the building cornice to 40 ~ 50cm, the outer row of pole high building cornice is 1 ~ 1.5m, the erection of two columns of body, and hung a dense mesh safety net. Erection of the 2. major rails erected scaffolding vertical and horizontal direction must be set with a sweeping rod, the project big cross bar step 1.5m, can meet the needs of floor operations, but should not exceed 1.5m. The big cross bar shall be equipped with the necessary horizontal connection, and it shall be connected by a long cartoon. It shall not be connected with a rotating shaft card, and the vertical inner row joint and the upper and lower joint of the same row need to stagger a vertical rod spacing. The cross bar is used when the big cross bar and the side of the upright pole are connected. 3. small bar erection: small