变位齿轮设计计算（Calculation of gear design）.docVIP

变位齿轮设计计算（Calculation of gear design） Design report of involute cylindrical gear drive Design information Designer Name= Zhu Jiacheng Design unit Comp= HeFei University of Technology Design date Date=2011-7-19 Design time Time=10:26:21 Two, design parameters Transfer power P=7.50 (kW) Transmission torque T=49.05 (N = m) Gear 1, speed n1=1460 (r/min) Gear 2, speed n2=199.66 (r/min) Transmission ratio i=7.3125 Prime mover load characteristic SF= slight vibration Working machine, load characteristic, WF=, uniform and stable Scheduled life H=10000 (hours) Three, layout and structure Structure form, ConS= closed type The gear 1 is arranged in a symmetrical arrangement of ConS1= The gear 2 is arranged in a symmetrical arrangement of ConS2= Four material and heat treatment Gear meshing type GFace= hardened surface Quality grade of heat treatment Q=ML Gear 1 material and heat treatment Met1=45 surface quenching Gear 1 hardness range HBSP1=45 to 50 Gear 1 hardness HBS1=48 Gear 1 material category MetN1=0 Gear 1 ultimate stress class MetType1=11 Gear 2 material and heat treatment Met2=45 surface quenching Gear 2 hardness range HBSP2=45 to 50 Gear 2 hardness HBS2=48 Gear 2 material category MetN2=0 Gear 2 ultimate stress class MetType2=11 Five, gear accuracy Gear 1, group I, accuracy JD11=7 Gear 1, group II, accuracy JD12=7 Gear No. 1, group III, accuracy JD13=7 Gear 1 tooth thickness deviation JDU1=F Gear 1 tooth thickness deviation JDD1=L Gear 2, group I, accuracy JD21=7 Gear 2, group II, accuracy JD22=7 Gear No. 2, group III, accuracy JD23=7 Gear 2 tooth thickness deviation JDU2=F Gear 2 tooth thickness deviation JDD2=L Six, gear basic parameters Modulus (normal modulus) Mn=12 (mm) End face modulus Mt=12.00000 (mm) Helix angle, beta =0.000000 (degree) Base helix angle, beta b=0.0000000 (degree) Gear 1 teeth number Z1=16 Gear 1 modification factor X1=0.500 Gear 1 teeth wide B1=25.00 (mm) Gear 1 tooth width factor phi d1=0.130 Gear 2 teeth number Z2=117 Gear 2 modification f