工艺名称（Process name）.doc

工艺名称（Process name） Tentering is plasticity is under wet conditions using cellulose, silk and wool fiber, the fabric width gradually widening to the required size and drying process, the fabric shape is stable, so called sorted. The fabric in some processing before such as scouring and bleaching, dyeing and printing process, often by warp tension, forcing the fabric warp elongation, weft shrinkage, and have some other disadvantages, such as uneven width, uneven selvedge, feel rough, flat with aurora. In order to make the fabric have uniform and stable door width, at the same time, it can also improve the defects and reduce the deformation of the fabric during the taking process. After finishing the dyeing and finishing process, the fabric should be finished by stretching. 2. pre shrinking (pre - Shrinking) Pre shrinking is a physical process to reduce shrinkage of fabric after immersion to reduce shrinkage. In the process of weaving, dyeing and finishing, warp tension and warp buckling wave tend to decrease. When the hydrophilic fiber is soaked and soaked, the fibers swell and the diameter of warp and weft yarns increases, thus increasing the warp buckling wave height, shortening the fabric length and forming shrinkage. When the fabric is dried, the swelling disappears, but the friction between the yarns keeps the fabric in a state of shrinkage. Mechanical pre shrinking is to wet the fabric first by spraying steam or spray, and then applying mechanical extrusion, so that the buckling wave height increases, and then it is dried by pine. The shrinkage of the pre shrunk cotton fabric can be reduced to below 1%, and the softness of the fabric feel will be improved due to the mutual extrusion and rubbing of the fiber and yarn. The wool fabric can be treated by relaxation and pre shrinking, and the fabric will be dried slowly after being soaked or sprayed with steam, so that the fabric will shrink in warp and weft direction. Shrinkage of fabric is also related to its struc