更换bObsweep标准或Pethair的保险杠更换传感器-iFixit.PDF

Replacing bObsweep Standard or Pethair s Bumper Sensors Replacement Replacing bObsweep Standard or Pethairs Bumper Sensors Replacement How to remove the sensors which tell bOb when he touches walls or obstacles and install new ones. Written By : Tatiana © iFixit — CC BY-NC-SA www.iFixit .com Page 1 of 7 Replacing bObsweep Standard or Pethair s Bumper Sensors Replacement INTRODUCTION The bumper sensors on bObsweep Standard and Pethair models are essential in directing movements and determining Bob s distance from obstacles. Video tutorial: [video: https :///watch?v=MHkxTVuLWMs] TOO S: Phillips #2 Screwdriver (1) © iFixit — CC BY-NC-SA www.iFixit .com Page 2 of 7 Replacing bObsweep Standard or Pethair s Bumper Sensors Replacement Step 1 — bObsweeps cover  Flip Bob over and remove the 7 screws around which hold the cover together.  Remove the main brush. Unscrew the holder, and lift the brush out. Reminder: Keep this screw separate from the others so you can use it later to reinstall.  Depending on your model, there may be only 6 screws installed on bObsweep. Step 2  There are two screw holes inside the brush compartment : one in the centre, one on the left end. Remove both and keep aside for reassembly .  There are five more screws around bObsweep s edges. Two are installed at the top and bottom, and one on the right end of the main brush. © iFixit — CC BY-NC-SA