万年历程序+电路图.pdfVIP

基于单片机的万年历系统设计 （一） 顶层文件 万年历 .C #includereg51.h #include LCD1602.h #include DS1302.h #define uchar unsigned char #define uint unsigned int sbit speaker=P2^4; bit key_flag1=0,key_flag2=0; SYSTEMTIME adjusted; uchar sec_add=0,min_add=0,hou_add=0,day_add=0,mon_add=0,yea_add=0; uchar data_alarm[7]={0}; /************ 键盘控制 ******************************/ int key_scan() //扫描是否有键按下 { int i=0; uint temp; P1=0xf0; temp=P1; if(temp!=0xf0) i=1; else i=0; return i; } uchar key_value() // 确定按键的值 { uint m=0,n=0,temp; uchar value; uchar v[4][3]={2,1,0,5,4,3,8,7,6,b,a,9} ; P1=0xfe; temp=P1; if(temp!=0xfe)m=0; P1=0xfd;temp=P1 ;if(temp!=0xfd)m=1; P1=0xfb;temp=P1 ;if(temp!=0xfb)m=2; P1=0xf7;temp=P1 ;if(temp!=0xf7)m=3; P1=0xef;temp=P1 ;if(temp!=0xef)n=0; P1=0xdf;temp=P1 ;if(temp!=0xdf)n=1; P1=0xbf;temp=P1 ;if(temp!=0xbf)n=2; value=v[m][n]; return value; } /*************************** 设置闹铃函数 *******************************/ void naoling(void) { uchar i=0,l=0,j; init1602(); while(key_flag2i12) if(key_scan()){j=key_value();write_data(j);if(i%2==0)data_alarm[l]=(j-0)*10;else {data_alarm[l]+=(j-0);l++;}i++;delay(600);} write_com(0x01); } uchar according(void) { uchar k; if(data_alarm[0]==adjusted.Yeardata_alarm[1]==adjusted.Monthdata_alarm[2]==adj usted.Daydata_alarm[3]==adjusted.Hourdata_alarm[4]==adjusted.Minutedata_al arm[5]==adjusted.Second) k=1; else k=0; return k; } void speak(void) {uint i=50; while(i) {speaker=0; delay(1); speaker=1; delay(1); i--; } } void alarm(void) {uint i=10; while(i) { speak(); delay(10); i--; } } /************************** 修改时间操作 ********************************/ void reset(void) { sec_add=0; min_add=0; hou_add=0;