电缆铺设规范（Cable specification）.docVIP

电缆铺设规范（Cable specification） 7.3 cable line 7.3.1 cable selection power cable type selection should be based on the environmental conditions and requirements of electrical equipment and product technical data and other factors in laying mode, to determine the general principles according to the following considerations: (1) in the general environment and places should adopt the aluminum core cable; the vibration and the places with special requirements, should use the copper core cable; large scale public building should also be used copper core cable. (2) cable laying underground, it is necessary to adopt armored cable protecting layer. In the absence of mechanical damage may place, also can use plastic sheathed cables or outer layer of lead (aluminum) cable. (3) the possible displacement of the soil (such as near the swamp, sand flow, large buildings) laying underground cables, the steel wire armored cable, or take measures (such as reserved cable length, with sheet pile or the row of piles to reinforce soil etc.) to eliminate the stress in cable cable displacement. (4) in a chemical corrosion or corrosion of stray current in the soil, should not be used for laying underground cables. If must be buried, should adopt anti-corrosion type cable or cable to prevent stray current corrosion measures. (5) the laying of pipe or cable row tube, should adopt plastic sheathed cable, also can use bare armored cable. (6) cable in the cable trench or cable tunnel, should not use flammable and flammable outer protective layer. Adopt the bare armored cable and bare lead (aluminum) cable or plastic sheathed cable. (7) the overhead cable should be used with cable coating or plastic. (8) when the cable laying in large height places, should adopt plastic draining cable or dry insulation cable, cable insulation. (9) power cable using three-phase four wire circuit, four core cable should be used. cable section, according to the general cable ampacity and voltage loss allowed allowed t