行场时钟（A clock）.docVIP

行场时钟（A clock） Take the feeling in the hand is not the same. LTPS TPO screen is the most typical, such as Toppoly 4.3 inch, 4.8 inch WVGA screen. The famous Aino V3000 is the use of Toppoly 4.3 inch WVGA screen, the effect is far better than TFT. In addition, the famous NOKIA N97 uses the TPO 3.2 inch screen. Of course, the most widely used and most rampant, the non TFT screen is. The TFT screen is divided into Japan and South Korea, Taiwan, and mainland three levels, its quality is basically decreased. South Korea SamSung, LG, SHARP as a typical, of course the price is always high. The Department of Taiwan to AUO, CMO, Hancai, Innolux as the representative of mainland China, such as BYD, boe. Chinese in the low-end market, basically use the Chi Mei IC, glass mosaic module, although although many different manufacturers, but the driver did not need to change the screen. But if the driver IC, driving to a minor adjustment. The following 6410 Samsung processor as an example to explain how to adjust these parameters. The hardware interface of LCD screen as shown below: The above is the LCD 40PIN interface circuit, the interface basically is compatible with most of the 4.3, 5 inch screen. 4.3 letters, such as screen Innolux, BYD, China, high color, Chi Mei, Choi Han; 5 inch screen such as Chi Mei, BYD, country, high color, color and other Chinese using the above interface. Although some driver IC screen is not the same, but they are all pretty close, you know a lot of IC to copy itself is copied in the China. According to the S3C6410 LCD driver, first of all, in the bootloader, some register parameters, configure the LCD configuration overlay, window register parameters, after entering the system, will call the LCD drive, will again brush a LCD register driver, eventually entering the system. Here mainly to explain some parameters about the LCD itself, the code is as follows: Case LDI_SMRP_LTE480WV_RGB: LDI_INF ((_T ([LDI:INF] Output Devce Type [%d] = LDI_ (SMRP) LTE480W