衬衫制作工艺流程（Shirt production process）.docVIP

衬衫制作工艺流程（Shirt production process） Shirt production process Process of homework Class: Class: student number: Name: Name: make a shirt clothing long size 170/88A (L) 72 (B) 108 bust shoulder sleeve (S) 46 (SL) 59 (N) 39 collar garment size table (unit): unit: garment size table (unit: cm) before long piece of clothing collar deep down shoulder sleeve depth waist shoulder neck wide chest width on the door N/5-1=6.8 S/10=4.6 B/5+1=22.6 bust L-3=69 /4=42.5 1.7 N/5-1.5=6.3 S/2-1.5=21.5 -1 B/4-1=26 S/2-0.5+2 (front shoulder pleat) =24.5 shoulder -1.3 B/4+1=28 N/5+0.4=8.2 S/2+0.5=23.5 23.5-1=22.5 after the 1 align post tablets (L-3) -1.5+4=71.5 over the shoulder (cover potential) 10 N/10+0.5=4.4 S/10-0.6=4 the sleeve piece sleeve placket cuff collar piece size: (unit: cm) patch AH 539 ~50.4 is measured long sleeve cuff cuff placket large slash Pleated cuff collar piece 25.22911 2*3 long and 25 wide and 619.5 two styles of figure four (a) process tool material preparation: fabric: Cotton Plaid 1.6m accessories: white non-woven lining 1m (two) process of discharging - cutting - collar - Ji - Lapel lapel. Turn in hot - nail bag bag over the shoulder - collar - splicing - - - sleeve sleeve seam sleeve sleeve cuff suture - - - - - the volume series button, pressing 1 keyhole discharge: according to the pattern size, cloth width fixed nesting. The cloth ironing, attention to the grain line lattice. 2: check the cutting size, pattern piece is correct. Then use a pin to hold the fabric, fabric and fixed pattern. Cut the attention of positive and negative pattern, so as not to cut out a piece of double fabric facing in the fold along the pattern edge line drawing. 3. The collar Lapel sewing is relatively positive, 1cm, 0.5cm and valgus line. The collar lining will. A folding ironing collar topstitching 1cm 0.5cm, then the 2 piece collar clip in front lapel sewing surface 1cm, 1cm valgus. White 8 buttons. In the 4 series over the lapel Lapel Lapel over front and left side alignment