建筑材料自重（Building materials self weight）.docVIP

建筑材料自重（Building materials self weight） See what geological report 1, first look at the evaluation of site and foundation selection of geological data in the proposal, good general situation of the site have a general understanding; 2, according to the physical indexes of geological profile and the soil geological structure, soil distribution, site stability and uniformity of site evaluation and understanding; 3, to determine the basic form; 4, according to the basic form of determining foundation bearing layer, embedment depth, soil data etc.; 5, the settlement data analysis; 6, if found unfavorable geological conditions influence the foundation, such as caves, caves, soft soil, groundwater and so on. Notice....... Groundwater geological reports often have such a word no if, during the exploration of groundwater with the basement, the venue for the impervious soil, such as rock, considers when the design pressure of foundation pit once the water, and the water is nowhere to go, if the design does not consider the trouble. 2 bar acceptance check what 1 anchor bar; The number and diameter of 2 steel; 3 bar spacing; 4 reinforced protective layer; 5 stirrup hook; 6 after pouring reinforced; 7 tie bar; 8 the bond length and joint rate; 9 reinforced joints; 10 bar certificate and test report. In the end of the 3 tank inspection check what In order to test tank is generally proven foundation soil and special soil conditions, the local treatment of abnormal foundation; the original drilling is required to supplement the original foundation design is revised, to confirm their own acceptance of materials and engineering of the external environment. Whether the 1 is for foundation soil by the geological sector to the design of the data layer, whether there is a difference, mainly by the personnel responsible for the investigation; 2 basic depth is up to the design depth, the bearing layer is in place or over excavation, foundation pit is the correct size, position and axis dev