网络命令（Network command）.docVIP

网络命令（Network command） Command line mode command network A ping command A ping command In the control window in the Windows (Windows 95/98/ME command Windows NT/2000 CMD interpreter, the interpreter), run Ping can see the command, it is a local computer and remote computer detection between the information transmission speed command, the command requires TCP/ support IP protocol, Ping will calculate a return to the information the time required from the local to the remote, hackers use this command to decide whether to attack the server, because the connection speed is too slow, would be a waste of time to spend too much cost of the internet. This command can also find each other through the domain name server IP address, we know that the domain name is for web browsing, when we see a good domain name address, to connect to it via Telnet, you must know the IP address, here is to use the Ping command. This command can be obtained by using the basic format directly run Ping, now assume that the target is /, you can enter in the console, after waiting to get the following information: P[2] with 32 bytes of data: Reply from 2: bytes=32 time=302ms TTL=240 Reply from 2: bytes=32 time=357ms TTL=240 Reply from 2: bytes=32 time=288ms TTL=240 Reply from 2: bytes=32 time=274ms TTL=240 Ping statistics for 2: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 274ms, Maximum = 357ms, Average = 305ms The message is: s IP address is 204.202... All the time is 305ms. So as to understand the use of time servers connect to each other. This command also has some special usage, for example by reverse IP server NetBIOS, now in the case of 7, the use of Ping with -a, enter the command in the console Ping -a 7, Its result is: Pinging POPNET-FBZ9JDFV [7] with 32 bytes of data: Reply from 7: bytes=32 time=96ms TTL=120 Reply from 7: bytes=32 time=110ms TTL=120 Reply from 7: bytes=32 time=110ms TTL=120 Reply from 7: bytes=32 time=109ms