基于mccb灭弧栅片变化对电弧电压的仿真与试验研究论文.pdfVIP

机械工程师 MECHANICAL ENGINEER 基于MCCB灭弧栅片变化对电弧电压的仿真与试验研究 1,2 1 武军亮 ， 王明娣 （1.摇苏州大学机电工程学院，江苏苏州215000 ；2.伊顿电气，江苏苏州 215000 ） 摘 要：塑壳断路器（MCCB）通常采用栅片灭弧系统来熄灭电弧，通过将故障电弧分割成很多段小的电弧,利用交流电弧的 近阴极效应,从而增加电弧的电压来使故障电流强制减零最终熄灭电弧。设计上通常的做法主要是提高触头开距以及增加 灭弧栅片两种方式，但这也会带来产品尺寸及成本的增加。文中在保持160A塑壳断路器灭弧系统尺寸不变的情况下，改变 灭弧栅片V型槽深度及表面镀层，并借助ANSYS耦合分析50kA分断过程中电弧运动的过程，选出其中最优的方案。最后通 过样机试验与模拟分析比较基本吻合，为后续类似产品的设计提供指导。 关键词：塑壳断路器；灭弧栅片；电弧电压；仿真分析 中图分类号：TM561 文献标志码：A 文章编号：１００２－２３３３（２０１7 ）06－０028－０3 Simulation and Test Study of the Arc Voltage Based on MCCB Deion Plate Change WU Junliang1,2, WANG Mingdi1 (1.SchoolofMechanicalEngineering,SoochowUniversity,Suzhou215000,China;2.EatonElectric,Suzhou215000,China) Abstract: Molded case circuit breaker (MCCB) commonly uses deion plate arc extinguishing system to extinguish the arc. The fault arc is divided into many small sections. Through the near cathode effect of AC arc, the arc voltage is increased to make the fault current compulsory reduction zero and extinguish the arc at last. Usual design is mainly to improve the distance between two contacts and increase the number of deion plate, but this will also increase the product size and cost. This paper keeps 160A molded case circuit breaker arc extinguishing system ’s size, and changes deion plate ’s V type groove depth and the surface coating based on ANSYS coupled analysis of the arc movement process under 50kA interrupting current. The best solution is selected. The re