人教版二级上语文计划.docVIP

平阴县实验学校二年级语文备课组工作计划 一、指导思想 本学期，我们组要全面贯彻党的教育方针，认真学习先进的教育思想和新课程标准，积极投身课堂改革，以更新观念为前提，以提高师资整体素质为核心，以提高课堂效率为重点，加强教学研究，不断解决教学中的新问题，努力培养和提高学生的创新精神和实践能力，全面提高教学质量。 一、学生情况分析 教师分析：二年级有8个班，八位语文教师，各担任一个班的语文教学工作。我们八位教师中最年轻的也已经工作七八年了，所以我们组算的上是一个有一定教学经验的队伍，而且大家工作都积极上进，踏实勤恳， 学生分析：二年级原有学生351人，新转入加转走的，人数没变。经过一年的习惯养成教育，注意力集中。。 学生家长对学生的期望都很高，但家长忙于，并没有太多的时间和精力督促孩子的学习因此，在教学过程中，因材施教，尽量从他们的实际出发，结合新课程的要求，促进学生的个性发展和语文素质的提高。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness