张静-小静的个人资料.doc

张静-小静静的个人资料 姓名；张静 昵称；小静静 生日；1999.11.09 身高；155cm(成长中） 星座；天蝎座 血型；O型 体重；44kg 爱好；听歌，唱歌 职业；学生， 喜欢的食物；牛奶 讨厌的食物；太甜的东西 喜欢的颜色；紫 喜欢的科目；钢琴 讨厌的科目；数学 喜欢的季节；秋天 讨厌的季节；冬天 喜欢的动物；狗 害怕的东西；蛇 喜欢的历史人物；武则天 喜欢的电影；少年go，男生学院自习室 喜欢的明星；本兮，tfboys，王俊凯 喜欢的歌曲；魔法城堡 喜欢的书籍；男生女生 喜欢的漫画；爆笑校园 喜欢的地方；有海的城市 平时嘴上最爱说的话是哪句；我晕 平时休息时喜欢做什么；玩游戏，睡觉，听歌 张静-小静静的代表作品有： 《写给tf组合的录音》 《我喜欢你》 《给十年后的我自己》 张静-小静静录过的视频： 《写给tf组合的录音》 《我把这个视频，送给王俊凯。》 张静-小静静的图片：  Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe su