太阳能控制器工作原理和使用说明（The working principle and instructions of solar energy controller）.docVIP

太阳能控制器工作原理和使用说明（The working principle and instructions of solar energy controller） principle Solar PV equipment (mainly belong to the part of the semiconductor material), it through the light after the photoelectric effect generated current. Because of the properties and limitations of materials and light, the current generation is fluctuant curve, if the direct current charge generated in the accumulator or direct supply to the load, it is likely to cause serious damage to the battery and the load, reduce their life. Therefore, we must take the current into the first solar controller, using a series of special chip circuit of the digital modulation, and add multiple charge and discharge protection, and the control technology of the unique adaptive three stage charging mode (Figure 1), ensure the battery and the load operation safety and service life. The load power supply, but also let the battery current flows into the solar controller, through its regulation, then the current into the load. The purpose of doing so: one is to stabilize the discharge current; the two is to ensure that the battery will not be a discharge; three is to monitor a series of protection to the load and battery. If you want to use the AC electric equipment, also need to load before joining AC inverter. The controller is in full accordance with the national industry standard stipulated content and design, its contents please refer to GB/T19064-2003 home solar photovoltaic power system technical requirements and test methods and other relevant information. Characteristic We produce various types of solar controller, adaptive digital control circuit has three stage charging mode, gas regulation, overpressure and overcurrent protection function, can effectively ensure the solar power supply system more secure, more stable and more long run. 1, adaptive type three stage charging mode Bad state of the battery performance, in addition to the normal life of aging, is mainly for two reasons: one is