光通讯器行业分析-2015.11.25.doc

光通讯器件行业分析-2015 一、光通讯产业链分析 上 游 中 游 下 游 2、光通信参与厂商分析 二、光通讯产业规模分析 1、光通讯主要业务领域市场规模 资源来源：单位：亿元（已转换为人民币） 通讯设备中国市场规模 资源来源：中研普华，单位：亿元人民币 3、光通信网络设备市场份额 资源来源：中科调研 4全球光通讯器件市场份额 资源来源：中科调研 光通讯元器件各领域需求 资源来源：中研普华 市场容量预测 资源来源：ElectroniCast 单位：亿元（已转换为人民币） 光通信LENS组件被广泛用于各种光器件中，如：调制器、衰减器、发射器、泵浦激光器模块、交换/光交叉连接、波长选择开关、ROADM、隔离器、环形器、扩束连接器组件、光滤波器模块、DWDM、可调滤波器、光传感器等有源和无源器件。 7、光通信LENS需求区域 资源来源：ElectroniCast 1、中国前十大光器件厂商 序号 厂商 2014年营收 产品 1 武汉光迅科技股份有限责任公司 4.33亿人民币 光纤放大器、波分复用器、光纤耦合器、光通信仪表 2 昂纳光通信（集团）有限公司 深圳日海通讯技术股份有限公司 2、台湾光通讯厂商列表（2015年4月业绩） the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge mea