flexural behavior of extruded dfrcc panel and reinforced concrete composite slab挤压的弯曲行为dfrcc面板和钢筋混凝土组合板.pdfVIP

Hindawi Publishing Corporation Advances in Materials Science and Engineering Volume 2012, Article ID 460541, 8 pages doi:10.1155/2012/460541 Research Article Flexural Behavior of Extruded DFRCC Panel and Reinforced Concrete Composite Slab Chang-Geun Cho,1 Bang Yeon Lee,2 Yun Yong Kim,3 Byung-Chan Han,4 and Seung-Jung Lee1 1 School of Architecture, Chosun University, Seosuk-Dong 375, Dong-Gu, Gwangju 501-759, Republic of Korea 2 School of Architecture, Chonnam National University, Gwangju 500-757, Republic of Korea 3 Department of Civil Engineering, Chungnam National University, Daejeon 305-764, Republic of Korea 4 Department of Remolding Architecture, Woosong Information College, Daejeon 300-715, Republic of Korea Correspondence should be addressed to Yun Yong Kim, yunkim@cnu.ac.kr Received 15 December 2011; Accepted 18 February 2012 Academic Editor: Nai-Qian Feng Copyright © 2012 Chang-Geun Cho et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This paper presents a new reinforced concrete (RC) composite slab system by applying an extruded Ductile Fiber Reinforced Cement Composite (DFRCC) panel. In the proposed composite slab system, the DFRCC panel, which has ribs to allow for complete composite action, is manufactured by extrusion process; then, the longitudinal and transverse reinforcements, both at the bottom and the top, are placed, and finally the topping concrete is placed. In order to investigate the flexural behavior of the proposed composite slab system, a series of bending tests was performed. From the test results, it was found that the extruded DFRCC panel has good deformation-ha