案例一使用交换机的命令行管理界面.DOC

案例九 静态路由实现网络互连 【背景描述】 【实现功能】 【使用设备】 设备类型 设备名称 设备数量 交换机 switch 2 路由器 三层交换机 双绞线 4 计算机 pc 2 【实验拓扑】 【实现步骤】 步骤1 在路由器Router1上配置接口的ip地址和串口上的时钟频率 Red-Giant(config)#hostname Router1 Router1(config)#interface fastEthernet 0 Router1(config-if)#ip address 172.16.1.1 255.255.255.0 Router1(config-if)#no shutdown Router1(config-if)#exit Router1(config)#interface serial 1 Router1(config-if)#ip address 172.16.2.1 255.255.255.0 Router1(config-if)#clock rate 64000 ！配置DCE端的时钟频率 Router1(config-if)#no shutdown 验证测试:验证路由器接口的配置 Router1#show ip interface brief Interface IP-Address OK? Method Status Protocol FastEthernet0 172.16.1.1 YES manual up up FastEthernet1 unassigned YES unset administratively down down FastEthernet2 unassigned YES unset administratively down down FastEthernet3 unassigned YES unset administratively down down Serial0 unassigned YES unset administratively down down Serial1 172.16.2.1 YES manual up up 查看接口的状态 Router1#show interfaces serial 1 Serial1 is up, line protocol is up !查看端口的状态 Hardware is HDLC4530B Internet address is 172.16.2.1/24 !配置IP地址 MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec, rely 255/255, load 1/ Encapsulation HDLC, loopback not set, keepalive set (10 sec) Last input 00:00:03, output 00:00:02, output hang never Last clearing of show interface counters never Input queue: 0/75/0 (size/max/drops); Total output drops: 0 Queueing strategy: weighted fair Output queue: 0/64/0 (size/threshold/drops) Conversations 0/2 (active/max active) Reserved Conversations 0/0 (allocated/max allocated) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 11 packets input, 880 bytes, 0 no buffer Received 11 broadcasts 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 74 packet