research on single-side long edge of hot rolled strip caused by asymmetrical stiffness of mill stand研究单边长边不对称所导致的热轧带钢轧机机座刚度.pdf

Engineering, 2011, 3, 900-904 doi:10.4236/eng.2011.39110 Published Online September 2011 (http://www.SciRP.org/journal/eng) Research on Single-Side Long Edge of Hot Rolled Strip Caused by Asymmetrical Stiffness of Mill Stand 1 1 1 2 3 Dian-Yao Gong , Jian-Zhong Xu , Dian-Hua Zhang , Zhong-Feng Guo , Cui-Ying Yang 1State Key Laboratory of Rolling Technology and Automation, Northeastern University, Shenyang, China 2School of Mechanical Engineering, Shenyang University of Technology, Shenyang, China 3Electro-mechanical Institute of Technology and Vacation, Panzhihua, China E-mail : dygong@21 Received May 11, 2011; revised August 4, 2011; accepted August 15, 2011 Abstract To analyze and solve the problem of single-side long edge of hot rolled strip in certain domestic factory, the asymmetrical deformation of rolls and strip in asymmetrical stiffness mill stand based on slit beam model, the strip profile and rolling force distribution at the exit of asymmetric stiffness stand mill were calculated using influence function method. Considering the character of in-site equipment and technology, a scheme of adjusting load distribution in finishing mill was made and the experiment was applied. Comparison of strip profile between new load distribution and the old one shows that the method can solve single-side long edge problem well. Keywords: Hot Rolled Strip Shape, Asymmetric Deformation, Effect Coefficient Method, 4-High Mill 1. Introduction est longitudinal section in horizontal direction. One I unit