07集中11备份配置.doc

集中转发，拓扑图如下： 如上图所示：默认情况下是AC1在工作，AC2处于待机状态。 1、在做1+1备份时，除IP地址不同外。其它都要一样，甚至连AC上的用户以及密码。 通常建议将AC1配置导出再仔细将AC2对应的IP地址修改，再导入AC2。这样更能保证数据的一致性。 2、以下配置是以一种手动来区分热点的实现方式，AP上线后为了要区分AP属哪个热点以及以哪个NAS—PORT—ID往上推送，故需要创建radio接口，然后加入到EBR中。这样EBR就会进行区分，如下类似配置： config ebr 1 service disable set bridge_isolation disable set bridge_multicast_isolation disable set ebr add interface radio1-0.2 set ebr add interface radio2-0.1 service enable AC1的配置如下： create ebr 1 CMCC-TEST config ebr 1 service enable exit ! interface eth0-2.1004 exit interface eth0-2.1005 exit ! interface ebr1 ip address 10.246.8.2/21 exit ! interface eth0-1 ip address 120.196.200.10/26 exit ! interface eth0-2 interface eth0-2.1005 ip address 192.168.9.254/24 exit ! interface eth0-3 ip address 10.10.11.3/24 exit ! interface eth0-4 ip address 10.202.15.10/27 exit ! interface lo exit ! interface sit0 exit ! ip route 0.0.0.0/0 120.196.200.1 ! ! create security 1 1 config security 1 security type open encryption type none set security index 1 exit create wlan 1 wlan1 CMCC config wlan 1 apply securityID 1 wlan apply interface eth0-2.1005 exit create wlan 2 wlan cmcc-test config wlan 2 apply securityID 1 wlan apply interface eth0-2.1005 exit create wtp 1 autoap modelamp;mac AP2400-IBM,0500G00P mac 00:27:1D:02:31:49 config wtp 1 wtp apply interface eth0-2.1005 set wtp sn AP2400IFM0507090900455 exit config radio 4 radio apply wlan 2 txpower 20 channel 6 exit create wtp 2 autoap modelamp;mac AP2400-IBM,0500G00P mac 00:27:1D:02:31:21 config wtp 2 wtp apply interface eth0-2.1005 set wtp sn AP2400IFM0507090900435 exit config radio 8 radio apply wlan 1 txpower 20 channel 1 exit set auto_ap_login interface add eth0-2.1005 set auto_ap_login save_config_switch enable ! interface radio1-0.2 exit ! interface radio2-0.1 exit ! config wlan 1 service enable exit config wlan 2 service enable exit config wtp 1 wtp used exit config wtp 2 wtp used exit config ebr 1 service disable set bridge_isolation disable set bridge_multicast_i