SANClient备份设置.docxVIP

环境介绍VMware SAN SAN Client Dedup(5200)这种方式下所有的数据流均通过SAN方式来传送。NBU 5200被配置为FT Media ServerBackupproxy1配置为SAN Client数据通过Backupproxy1通过SAN读取后，通过SAN网络传送到NBU5200NBU5200上实现重复数据删除目前NBU5200已经可以通过手工方式开启SAN Client支持NBU5200近期将实现SAN Client官方支持(GUI界面?)SAN Client方式传输有如下特点：SAN Client广泛支持各种类型的OS。SAN Client方式下，只能支持Media Server端重复数据删除。NBU 5200上手工开启FT Media Server方法卸载HBA卡驱动[root@netbackup7 ~]# /usr/openv/netbackup/bin/admincmd/nbftsrv_config -nbhbaInstalling nbhba driver.Uninstalled WinDriver for FT Server mode. It may be necessary to temporarily unload your QLogic drivers to free up the ports for the nbhba drivers.This is an optional step. If you choose not to do this, the nbhba drivers may not have access to the HBA ports until a subsequent reboot.Would you like to unload and reload your native QLogic drivers now? [y,n] (y) Are you sure you want to unload QLogic driver: qla2xxx? [y,n] (y) Removing qla2xxx. Cannot continue since qla2xxx is in use and cannot be removed. Pleaserelease references to qla2xxx before trying the install again.该步骤可能不成功，主要是qla2xxx驱动绑定到内核中了。编辑/etc/modprobe.conf注释掉qla2xxx 模块[root@netbackup7 boot]# cat /etc/modprobe.confalias eth0 forcedethalias eth1 forcedethalias eth2 forcedethalias eth3 forcedethaliasscsi_hostadaptermptbasealias scsi_hostadapter1 mptsas#alias scsi_hostadapter2 qla2xxx alias scsi_hostadapter3 usb-storage 编辑/etc/modprobe.d/blacklist文件，在文件尾添加 blacklist qla2xxx重启机器并再次运行nbftsrv_config-nbhba命令检查是否成功[root@netbackup7 ~]# /usr/openv/netbackup/bin/admincmd/nbftsrv_config -mode nbhba installed获得对应的HBA卡WWN号[root@netbackup7 ~]# /usr/openv/netbackup/bin/admincmd/nbhba -l 1 2432 21:00:00:1B:32:91:E0:F9 QLE2462 0 0 1432 2432 21:01:00:1B:32:B1:E0:F9 QLE2462 1 0 143 [root@netbackup7 ~]# /usr/openv/netbackup/bin/admincmd/nbhba -L Card #1 HBA Index #1 Device ID = 2432 World Wide Name = 21:00:00:1B:32:91:E0:F9 Model Name = QLE2462 Port = 0 Mode = initiator (designated for other use)(143)HBA Index #2 Device ID = 2432 World Wide Name = 21:01:00:1B:32:B1:E0:F9 Mod