北电无线基站设备简介v2.0.ppt

Nortel 基站 设备简介 第一节 Nortel BTS 家族设备概览 GSM 结构 BSS 子系统结构 BTS 模块 图解 Nortel BTS 设备- S2000E and S4000 BTS 配置表-最大配置与发射功率 BTS S4000 室内 BTS S8000 室外 BTS S8000 室内 BTS e-小区 第二节 BCF 以及 CBCF 模块 BTS 一般图解 Compact BCF-物理面板观察 BCF 主要功能 BCF: 两种版本 Compact BCF-双工配置 第三节 TRX 模块 BTS 一般图解 S8000 功能模块 TRX 位置图解 TRX 结构 DRX 模块-物理组织结构 DRX 模块-图解 功率放大（PA）模块组合图解 Power Amplifier 功率放大-图解 第四节 耦合系统 S8000 耦合功能模块-位置图解 耦合器设备- 模块组合图解 3种耦合器 耦合系统-概览 耦合系统中话音通路: MS to BTS（上行） 耦合系统中话音通路: BTS to MS（下行） 附：标准耦合-两天线小区配置 附：Stepped 耦合配置-H2D and H4D 附：混合耦合配置- H2D and H4D: 2S448 带分集 2 TRX 配置耦合器连接 带分集 3 TRX 配置耦合器连接 第五节 S8000 室内型 S8000 Indoor 机柜物理面板图解 电源供应 机柜与TRX配置 3机柜连接配置 第六节 操作与维护 OMC-R（无线操作与维护终端） TIL-当地操作维护 TIL-BTS 配置 TIL- 主操作菜单 针对小区进行操作维护 BCF functionality are: Abis 接口 management, GSM time distribution, 外围 告警s and command management, Operation Maintenance, backup by 冗余 or duplication of its main units, signaling concentration/deconcentration. The BCF manages the information for a 基站 whatever its 配置 (omni or sectorial). A 交换over from one CMCF 板 to the other in the event of an error on the active one ensures 冗余. A 冗余 channel between both CMCF 板 ensures a permanent exchange of data and 时钟s. From V11.2 the 交换over process is enhanced. At 交换over time, the 双工 of the CBCF is now transparent for the networks: for all established communications, for all dropped BTS. During the 交换over (8 seconds) the BTS operates in a degraded mode: no more OML and RSL 链接s, no call establishment, no handover. The Abis downloading is not 双工. The downloading session must be restarted. The DRX is the 模块 of the S8000/8002/8006 and S2000HL BTS, which includes: the 帧 处理器, the RX receiver, the TX driver, the 电源供应. The necessary amplification for transmission is achieved by a separate Power Amplifier (PA). The use of DRX by separating the TX Power Amplifier (PA) from the rest of the transmit chain, allows different power classes of transmission (S2000HL) to be envisaged. The DRX 模块 is housed in a closed box, with all 连接头 on the front panel. Dimens