压接和焊接（Crimping and welding）.docVIP

压接和焊接（Crimping and welding） Crimping and welding Overview of crimping technology 1.1 history The technique of pressing pins on a printed circuit board has been in use for more than 20 years. In the beginning, the pin is used to fix the pin on the printed circuit board to prevent slippage in the welding process. Crimping technology develops with the development of printed circuit boards, from single panel to double sided panel to multi board. Before fully grasp the multilayer technology, people are already using stacking technology, the use of a synthetic insulating film will be a few pieces of printed circuit board are separated, the through hole is pressed into the connecting column are printed together. After the development of multilayer printed circuit board technology, this method has obviously been used again, leaving only a concept of crimping. In twenty years, crimping technology has developed into various forms after we use today: as a widely accepted and used without welding technology, it used to be a connector plug connection to a printed circuit board, with high reliability, safety and easy operation. 1.2 basic process Crimp connection, as the name suggests, is to press a through sized plug into a through-hole through which a printed circuit board is drilled. The basic element is that the joint diameter of the pin must be greater than the aperture. This leads to the deformation of the material on the mating face of the pin and hole, and the deformation of the pin or through hole will keep the tight fit between the two. There are two types of crimp connectors: Hard pin, it will not deform during insertion The flexible pin is deformed when inserted into the through hole of the printed board The following two diagrams describe a flexible pin and a hard pin insert. In the two method, the flexible pin technology is more suitable for crimp connection. Hard pin is mainly used in the multilayer printed circuit board technology mentioned above, and is used for t