ubuntu下编程步骤（Ubuntu下编程步骤）.docVIP

ubuntu下编程步骤（Ubuntu下编程步骤） Ubuntu write a C program and the specific steps for debugging is like? Satisfactory answer You can also open the terminal if you install Gcc or not: After entering VI, press I to edit the status, Enter your C program. After the input is complete, press ESC to enter the command: W 123.c Ctrl+z launches VI Enter in terminal: GCC 123.c If correct, the a.out file will be generated Enter in the terminal:./a.out can run your c! The basic operation of VI Enter VI After the system prompt symbol enters VI and the file name, you can enter the VI full screen edit screen: $VI testfile One thing to pay special attention to is that after you enter the VI, you are under Command mode, and you have to switch to Insert mode to enter the text. Users with VI for the first time will want to use the keys to move the cursor up and down, the computer has been called, and put himself half dead, so after entering the VI, do not move, After converting to Insert. Switch to the Insert? Mode Command mode to edit the file in I, a or o button you can enter the Insert mode. You can start typing at this time. I: inserts the inserted text from where the cursor is currently located. A: to increase, the next word at the cursor is beginning to enter the text. O: to insert a new line, began to enter text from the beginning. Insert switch to Command mode, press the Esc key You are currently in Insert mode, and you can only type all the time. If you find a typo, want to move backwards with the cursor keys to delete the word, Just press ESC to convert back to Command mode, and then delete the text. Leave VI and save files In Command mode, you can enter Last line mode by colon: , for example: W filename (enter w filename), and leave the article in the specified file name filename) : WQ (enter WQ) because it has specified the file name testfile when entering, so it will write to testfile and leave VI) Q! (enter Q), force to leave and discard the edited file Command mode function key