ug编程拐角设置（UG programming corner settings）.docVIP

ug编程拐角设置（UG programming corner settings） UG processing module CAM corner deceleration settings UG processing module CAM corner deceleration settings: UG4.0 corner settings detailed UG4.0 in the selection of circumference feed rate compensation, corner deceleration function is useful, otherwise, only a small angle deceleration function, can not play a big role. Compensation factor: The minimum compensation factor is the minimum value of the deceleration. When the minimum compensation factor is set to 0.2, then the deceleration feed is 0.2*F, or 0.2 times the feed rate The maximum compensation factor is the maximum value that indicates acceleration after deceleration. When the maximum compensation factor is set to 2, then the acceleration feed is 2*F, or 2 times the feed rate, Generally set to 1, and the same feed. Fillet: as required, no, on the side wall, all the knife Road, generally choose in the side wall can The radius is the size that is at the corner of the R angle, the bigger the R value reduction more gentle, but the corner runs more, the R value is generally not more than 1 The minimum radius is the minimum R angle size at the corner, generally greater than 0, smaller than the fillet radius. Deceleration Length selection tool diameter percentage The percentage of the diameter of the tool indicates the distance from the beginning to the corner. The greater the percentage, the slower the deceleration, and the smaller the tool damage. Generally, it is 200 Start at 2 times the knife distance and slow down The deceleration% indicates the minimum feed rate of the deceleration, that is, the feed rate at the corner, that is, X/100 times the feed, and the X is the value set by itself, which is usually based on the amount of feed The number of steps I usually set to 3 steps, so that slow down and acceleration are very smooth, slow down in 3 steps, speed up 2 steps The maximum and minimum values of the sharp angle are set as default values Note: only deceleration% par