变中求胜（Change the win）.docVIP

变中求胜（Change the win） Method for determination of slagging of coal I. brief introduction of methods 3 ~ 6mm size of the specimen is loaded in the gasification device, with charcoal ignition, under blast intensity under the gasification (combustion). Specimen burn stopped after the blast, cooling, the residue of weighing and screening, to the quality of clinker percentage greater than 6mm said the slagging of coal. Two. Noun explanation 1, slagging rate Sample gasification in blast strength under the provisions of the tender and burned the mass percentage of ash particle size greater than 6mm of total ash slag, called the specimen in the blast intensity under the slagging rate. 2, blast strength When the sample is gasified or burned, the air passes through the mean velocity of the cross section of the grate, expressed as m/s. 3, maximum resistance The maximum resistance of a material layer to an airflow during gasification or combustion, as indicated by hPa. 4, reaction time When the sample is gasified or burned, the time elapsed from the start of the ignition to the cessation of combustion is indicated by Min Three, instruments, equipment and materials L and slagging tester: as shown in Figure 1 2, blower: air volume is not less than 12m3/ h, wind pressure is not less than 49hPa (500mmH2O column). 3, the muffle furnace heating chamber inside the furnace is not less than the following dimensions: height 140mm, width 220mm, depth 320mm. The back wall or upper wall shall have vent holes and be equipped with a temperature controller. Figure 1 Fertility tester 4, industrial balance: maximum weighing 1 kg, sense of quantity 0.01g 5, vibrating screen machine: reciprocating, frequency (240 + 20) min-1, amplitude (40 + 2) mm. 6, round hole sieve: sieve hole 3mm and 6mm, and equipped with sieve cover and screen bottom. 7, U type pressure gauge: can be measured not less than 49hPa (500mmH20 column) pressure difference. 8, with a hole shovel: area of l00mm * IO0mm, while high 20