电脑小问题不求人--鼠标软驱打印机硬盘风扇常见事故处理（Computer small problem ask for help -- mouse, floppy disk, printer, hard disk fan, common accident treatment）.docVIP

电脑小问题不求人--鼠标软驱打印机硬盘风扇常见事故处理（Computer small problem ask for help -- mouse, floppy disk, printer, hard disk fan, common accident treatment） Computer small problem ask for help -- mouse, floppy disk, printer, hard disk fan, common accident treatment,.Txt mouse The fault analysis and maintenance of the mouse is relatively simple, and most of the failures are caused by bad contact or key contact, broken line, mechanical positioning system, dirt and so on. A fault is caused by internal components of the mouse or circuit weld, which mainly exists in some inferior products, especially in the light emitting diode, IC circuit damage. What about the mouse button failure? 1, the mouse button without action, this may be because the mouse button and circuit board microswitch is too far away, or click on the switch, after a period of use, the ability to rebound. Open the mouse, and stick a thick plastic sheet under the mouse button. The thickness should be determined according to the actual needs. After the processing, you can use it. 2, the mouse button to bounce, this is possible because when the button below in the micro switch contact piece bowl fault, especially plastic reed after long-term use is easy to break. If a three button mouse, then it could be a key middle down the emergency. If it is a good quality original brand mouse, you can weld, disassemble the microswitch, and carefully clean the contact. After some grease, it may be repaired. What can I do if I cant find the mouse? 1, the mouse and the host connection, serial or PS/2 interface bad contact, carefully connect the line, restart the computer. 2, the main board of the serial port or PS/2 interface damage, this situation is rare, and if this is the case, had to replace the motherboard or use a multi-function card. 3, bad contact with the mouse line, This situation is relatively common. Poor contact points, in the mouses internal data line and circuit board solder joints, generally maintenance is not difficult. The