覆膜中的一些问题与解决方案（Some problems and solutions in laminating）.docVIP

覆膜中的一些问题与解决方案（Some problems and solutions in laminating） Some problems and solutions in laminating I. Preface In finishing in the film is an important process in the printing process, although not very complicated, but in the operation and process design of film, often because of the lack of full understanding of the film itself and printing, and often this or that problem. In this paper, some problems often encountered in laminating are analyzed, and some solutions are put forward. Covering film is a comprehensive technology, it involves many factors, such as plastic film, adhesive, solvent, printing, surface ink layer, mechanical control and environmental conditions, etc.. In order to obtain high quality coated products, it is necessary to control the changes of these factors in the process and coordinate the relationship between them. Two, processing technology The process for preparation, coated plastic film, adhesive coating roller is installed to set the process parameters (drying, oven temperature and hot pressing temperature, pressure, speed) to try to film sampling detection, formal film, rewinding or shape segmentation. 1. process preparation. Whether the preparation is sufficient has a great influence on the normal production of the film covered production, the improvement of production efficiency and the quality of the product. The preparation of film production should include: inspection of printed matter to be covered, selection of plastic film and preparation of adhesive. (1) inspection of printed matter to be printed. The inspection of coated prints is different from the quality inspection of ordinary printed matter. Mainly for the impact of large film projects, such as whether the surface of powder, ink is fully dry, printed matter is smooth, and so on, once found problems, Measures should be taken in time. (2) selection of plastic film. The selection of plastic film includes selection of plastic film and quality inspection and slitting and coiling.