剥色回修技术（Stripping correction technology）.doc

剥色回修技术（Stripping correction technology） Keep warm until the dye is finished May be sucked up by the fiber. 4.1. 2 of flower color method can be used to add the subtractive part to the original depth of dye. Na2CO3 5-10% (equivalent to 10-20g/l) Peregal O 10-l5% (equivalent to 20-30g/l) Bath ratio 1:20-1:25 The temperature is 98 degrees centigrade Time 1:30--2:00h Process: heating up, walk 2 - -70 degrees, walk 2 ---98 degrees, heat 4 way --- cool down, wash 2 The subtractive fabric cylinder to use hot water washing, wash with cold water to clean, and finally stained. 4.1.3 severe color flower process: 36B NaOH: 1%-3% (equivalent to 3-10g/l) Peregal O: 15 ~ 20% (equivalent to 30-40g/l) Synthetic detergent: 5%-8% (equivalent to 15-20g/l) Bath ratio 1:25-1:30 The temperature is 98 degrees centigrade Time 20min 30min (until all decoloration) After stripping, gradually cool down, fully washed to net, and then 0.5mL acetic acid, 30 DEG C, 10min, fully neutralize the residual alkali, and then rinse with clean water, re dyeing. For example: Camel full stripping, color is light yellow, if dyed fawn, light grey. 4.2 polyester woven look for flower processing example 4.2.1 light colored flowers: A flower repair agent or high temperature leveling agent L-2 g / L, re heating to 135 DEG C for 30min. The original amount of additional dye l0%-20%, pH = 5 (0.5g/l acetic acid), can eliminate the fabric dyeing, splash, color difference and color effect, consistent with normal production pattern. 4.2.2 severe color flower: Sodium hypochlorite 2-5 g / L, Acetic acid 2-3 g / L, The treatment was started at 30 DEG C, and the temperature was increased to 100 DEG C at 2 min / for 60 min, and then the cloth was washed out. 4.3 cotton fabric dyeing with reactive dye dyeing process: Stripping, oxidation, re dyeing 4.3.1 stripping 1) process recipe: Insurance powder 5-6 g / L 2-4 g / L peregal O 36B 12 -15 mL / L caustic soda The temperature is 60 degrees -70 centigrade Bath ratio l:lO Time 30m