鉴别水货手机与高仿手机的技巧（Identification of parallel mobile phones and high imitation mobile phone skills）.docVIP

鉴别水货手机与高仿手机的技巧（Identification of parallel mobile phones and high imitation mobile phone skills） High imitation mobile phone and mobile phone smuggled goods identification techniques 1, shell. The new machine casing joint is compact, the gap is smooth, without burr. Refurbished machines generally use the imitation of the original shell, the gap is not smooth, burr, mobile phone shell two parts easy to appear is not tightly closed, leaving a gap phenomenon. The differential can be used when the small finger nail try into the mobile phone cover joint. If you can insert, is a refurbished machine. On the same matte shell surface like a new machine, and small particles of the mobile phone, it is absolutely not to buy. This machine shell paint is sprayed up JS, for a long time, the paint will fall off (the dust on the casing is no small particles, when painting vacuum caused); 2, opened a new building there is a faint smell of sandalwood, if the renovation, JS will conduct a beauty of body appearance, despite the smooth but not dry, or turn off the battery cover after the smell rubber, plastic taste, or smell the chemicals; 3, a keyboard and a data line interface. Because of the long-term data line plug the charger plug, because of the renovation of charging machine interface will be difficult to eliminate black scratches. Keyboard refurbished machines used in the old machine or modelled keyboard keyboard. This keyboard is common feel relatively soft, no new keyboard toughness; 4, charging test. Best long charging time, generally in more than 10 minutes. Because there are many renovation of charging machine for a long time would be turned off. This is a refurbished machine to determine a very effective way; 5, SIM card chip contacts and the battery contacts. The two contact JS is generally not replacement. If the renovation is, then the SIM card chip contacts will be left clear traces of friction, shiny look, which is caused by too much friction. If the new machine is not