surface modification of light alloys by low-energy high-current pulsed electron beam轻合金表面改性的低能耗大电流脉冲电子束.pdfVIP

Hindawi Publishing Corporation Journal of Metallurgy Volume 2012, Article ID 762125, 10 pages doi:10.1155/2012/762125 Research Article Surface Modification of Light Alloys by Low-Energy High-Current Pulsed Electron Beam X. D. Zhang,1 S. Z. Hao,1 T. Grosdidier,2 J. X. Zou,3 B. Gao,4 B. Bolle,2 N. Allain-Bonasso,2 Y. Qin,1 X. N. Li,1 and C. Dong1 1 Key Laboratory of Materials Modification, Department of Materials Engineering, Dalian University of Technology, Dalian 116024, China 2 Laboratoire d’Etude des Microstructures et de Mecanique des Materiaux (LEM3), CNRS UMR 7239, ´ ´ Universite Paul Verlaine-Metz, Ile du Saulcy, 57045 Metz, France ´ 3 Shanghai Engineering Research Center of Mg Materials and Applications, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China 4 School of Materials Science and Engineering, Shenyang University, Shenyang 200240, China Correspondence should be addressed to X. D. Zhang, zhangxiangdong0803@ Received 16 February 2011; Revised 17 August 2011; Accepted 9 December 2011 Academic Editor: Stefano Gialanella Copyright © 2012 X. D. Zhang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This paper reviews results obtained by the research groups developing the low-energy high-current pulsed electron beam (LEHCPEB) in Dalian (China) and Metz (France) on the surface treatment of light alloys. The pulsed electron irradiation induces an ultra-fast thermal cycle at the surface combined with