survey of bgfa criteria for the cu-based bulk amorphous alloys调查bgfa标准铜元素大部分非晶合金.pdfVIP

Hindawi Publishing Corporation Journal of Metallurgy Volume 2011, Article ID 895146, 5 pages doi:10.1155/2011/895146 Review Article Survey of BGFA Criteria for the Cu-Based Bulk Amorphous Alloys D. Janovszky, K. Tomolya, M. Sveda, and A. Roosz Hungarian Academy of Science-University of Miskolc, Materials Science Research Group, Miskolc-Egyetemvaros H3515, Hungary Correspondence should be addressed to D. Janovszky, fekjd@uni-miskolc.hu Received 25 August 2010; Revised 18 November 2010; Accepted 24 November 2010 Academic Editor: Livio Battezzati Copyright © 2011 D. Janovszky et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. To verify the effect of composition on the bulk glass forming ability (BGFA) of Cu-based alloys, properties have been collected from the literature (∼100 papers, more than 200 alloys). Surveying the BGFA criteria published so far, it has been found that the atomic mismatch condition of Egami-Waseda is fulfilled for all the Cu-based BGFAs, the λ value being above 0,3. The Zhang Bangwei criterion could be applied for the binary Cu-based alloys. The Miracle and Senkov criteria do not necessarily apply for Cu based bulk amorphous alloys. The critical thickness versus γ = T / (T + T ) plot of Lu and Liu extrapolates to γ = 0.36, somewhat x g l higher than the 0.33 value found in other BGFA alloys. The Park and Kim parameter correlates rather poorly with the critical thickness for Cu based alloys. The Cheney and Vecchino parameter is a good indicator to find the best glass former if it is possible to calculate the exact liquids projection.