系统找不到光驱收集的解决方法（The system could not find a solution for optical drive collection）.docVIP

系统找不到光驱收集的解决方法（The system could not find a solution for optical drive collection） Text: Two days ago, boot suddenly found the system CD-ROM can not find. Depressed, he did not do what, that is the data line problem can be changed, or the old way, remember that in order to speed up the start, disable the floppy drive, re open in CMOS, floppy drive is there, but not the same CD-ROM. See the motherboard detected CD CD-ROM in CMOS, I think it is the problem of the system, the online search information, that is likely to be the device manager IDE ATA/ATAPI controller driver problem, also think of yesterday have drive device type in a program into a free the original, automatic detection. Transfer mode for DMA (if available) after the change, restart the computer, and finally find the drive, the problem resolved. Attach relevant information: CD-ROM lost most of the time we are in the installation of new software or a new driver appears, we may also inadvertently modify the CMOS or CONFIG.SYS configuration settings, and because the machine is infected with a virus. Hardware reasons 1. the data line is reversed or the data line is damaged Sometimes just a little wrong, but full circle, this shows that in order to solve the problem must be cautious, and a keen observation. When the CD-ROM is lost, you should first check whether the data line of the drive is connected (red or red), whether it is loose or not. If you are sure there is no problem in the other place and the data line of the drive often moves, you should try to replace a data cable. 2. jumper settings and hard disk collision When the drivers jumper and the same data line connected to the hard disk phase, there will be no drive (also may not have a hard disk), then as long as the drivers jumper jump and hard disk is not the same. In order to improve data rates, it is better to separate the hard disk from the optical drive on the two IDE interfaces. 3. power line fault, lack of +5V voltage or +5V voltage, power sup