615 pemnet（615年pemnet）.pdfVIP

® BULLETIN SI THREADED INSERTS FOR PLASTICS SI 615 Rev 617 SI® THREADED INSERTS FOR PLASTICS • SI® inserts are typically specified in applications where strong, durable metal threads are required in plastic material, especially where frequent assembly and disassembly of the unit for service or repair is necessary. • Applications for SI® products include: electronics (including wearables, smart phones and hand held devices), automotive, aerospace and defence, medical, transportation, industrial and recreational equipment. • SI inserts are available in brass, stainless steel and aluminum. • SI inserts are available in a large variety of ultrasonic / heat staking, molded-in or press-in types. • Aluminum and stainless steel inserts for plastics offer lead-free alternatives to leaded brass typically used for brass inserts. – Lead-free inserts offer alternative to brass to address environmental active use and end-of-life recycling concerns. – NEW aluminum inserts are approximately 70% lighter than brass equivalents and made from lead-free aluminum. – Stainless steel inserts are typically stronger than brass and may offer better protection from certain types of corrosive agents. PART NUMBER DESIGNATION AND MATERIAL AND FINISH SPECIFICATIONS IU B - 440 - 2 Length Code (where applicable): See individual product charts for actual corresponding dimensional lengths. Thread Code: