牵伸工操作规程（Drafting procedure）.docVIP

牵伸工操作规程（Drafting procedure） Draft tender rules for safe operation The drafting process is quite high in a very strong sense of responsibility, work conscientiously, flexible degree of work, to ensure that each value of Turners personal safety, operation actions by the two person to complete. 1, into the workshop overalls, work wear hats, wear flat shoes, otherwise the posts are not allowed. 2, not allowed to wear watches, earrings, rings into the workshop. Get the hook knife ready before entering the workshop, Production tools, such as special tools. 3, the value is not allowed on the Turner class, but does not allow for classes, such as a violation of fire changji. 4 before driving, check whether the heating system is normal. The first is to press the button. Say hello on both sides of the platform, get ready before you drive, and then have a full-time driver. 5, the machine and the control cabinet is not allowed on the misplacing things. 6, after the end of the drive to travel frequently inspection, not channeling Gang, get together, chat, drawing No disk wrapped large group. Once around the large, should stop postprocessing. 7, hand inserted into the bobbin and dial out bobbin must be pedal brake for spindle stop After the operation, extubation no finger inserted into the pipe run, bobbin spindle insert must be inserted in the end. 8, roller, roller drafting disc or leather and the rotor of the filament, must According to the working method of operation method. To deal with drawing plate of fuzz, stand sideways to the right of the drawing plate, avoid the hook knife moving direction, right hand grip flat hook finger tip should not stretch out. In the meantime, leave the hook on your left and leave the draft slightly. Hook wire device should be flexible, must not be allowed to pick down the waste from drawing plate by hand, to prevent accidents caused by waste handgrips. The roller top roller filament must stay stop rotating can gently cut filaments, lest cut roll