钢筋笼计算（Reinforcement cage calculation）.docVIP

钢筋笼计算（Reinforcement cage calculation） There are three parts. First, calculate the main reinforcement, that is, the length of the main reinforcement, and second to calculate the external stirrups. According to the number of turns, third of the internal bracing is calculated according to the number of turns. The first step is to calculate the length of all the bars in the steel cage. The second step, apply Formula: steel weight = L * 2D * 0.00617 L= steel bar length: M D= rebar diameter: mm The weight per meter. The calculation formulas of reinforced The calculation of the weight per meter of reinforced formula Self multiplying diameter of reinforcement Make sure you remember the units per centimeter Take zero point six one seven again That is, the steel is heavier per metre Theoretical weight calculation method of steel The angle: per weight (kg) * =0.00785 (edge width + edge thickness - edge thickness) x edge thickness The bar: per weight (kg) =0.00617 * diameter * diameter (Note: the same steel and round steel) The flat: per weight (kg) =0.00785 * thickness * width The pipe: per weight (kg) =0.02466 * * wall thickness (diameter - thickness) The plate: per weight (kg) =0.785 * thickness The calculation formula for the non-ferrous metal plate: the weight per square meter (kg) = weight * thickness All kinds of non-ferrous metals are as follows: 8.9 the proportion of copper plate of brass 8.5 7.2 lead 11.37 2.8 aluminum zinc plate The tread plate: the weight per square meter (kg) =2.96* thickness The copper: per weight (kg) =0.02796* thickness (diameter * thickness) The brass: per weight (kg) =0.02670* thickness (diameter * thickness) The meaning of reinforcing bar lofting The general called reinforcement detailing, referred to as steel, this work belongs to the construction unit, the main work is the design drawing of the reinforcement, deepen refinement, and then handed over to the steel construction, and is responsible for the project reinforced the final work. Beca