钢筋下料（Reinforcement blanking）.docVIP

钢筋下料（Reinforcement blanking） Steel bar cutting and calculation of flat drawing: First, the beam (incomplete, to be completed later): 1. the length of welding shall be calculated by binding, and the cost of welding shall be calculated without further calculation. The cost of mechanical connection shall be determined by the agreement between the two parties. 2. is more than 12, 8 meters a lap, with less than 12, 12 meters a lap. 3. beam end encryption zone (Level II) length =1.5hb. HB - Liang Gao 4. binding overlap area should be encrypted stirrups, mechanical connections without stirrups encryption requirements. 5. quota calculation, only within 10 phi and phi 10 outside the two categories of billing. 6. according to the latest 03G101 atlas, bearing negativereinforcement toward the beam length of the first and second skin skin according to 1/3 large span length value for the original concentration (defined as negative reinforcement of the bearing beam to the length of the first large span length value 1/3 according to the skin, second skin according to the 1/4 value for large span length). Two, board: Plate tendons are mainly: 1) force tendon (one-way, two-way, single layer, double deck); 2) negative ribs of support; 3) distribution bars; 4) additional reinforcement (additional reinforcement at corner, additional reinforcement at hole) 5) support the steel bar (double steel bars support the upper and lower layers) 1. tendons: Bottom reinforcement length L=, net length + left bearing max, {b/2, 5d}+, right bearing, Max, {b/2, 5d}+, both ends of bent hook (if it is grade I reinforced bar); The length of gluten is L=, net length is +2 La (both ends are end support) B -- bearing width, D - steel diameter. Number of root = (net length buckle impairment) / cloth spacing +1 2. negative ribs and distribution bars: Negative reinforcement length = Design negative reinforcement length + left bend + right bend [plate thickness -2 * protective layer (only one protective layer is