铜镜修补（Mirror repair）.docVIP

铜镜修补（Mirror repair） See some of the faults and defects of residual mirrors can often be in the collectibles market, especially in the period of Warring States and Han Dynasty and the Tang Dynasty bronze mirror, because one thousand or two thousand years ago buried in the tomb, coffin collapse pressure, corrosion and environmental medium loss, and the mirror itself a more brittle material, thus causing more damage. It is a pity that a fine piece of bronze mirror has become a mirror. But not for profit collectors, it may not be a bad thing. In the market flooded with fakes, residual lens after all is true, also can enjoy the exquisite bronze mirror pattern, discusses various inscription meaning, design idea and characteristics of the times can also study various periods of ancient bronze mirror pattern, explore the mirror technology. The price of the mirror is much lower than that of the good mirror, which enables the working class to get involved in collecting, appreciating and researching. I was shy, often buy some broken mirror, a remnant of the mirror, especially the residual fine spot mirror. Some of the broken mirrors had been repaired briefly, and they were mostly bonded with cheap organic adhesive. These adhesives such as polyvinyl acetate, cellulose nitrate, etc., for the room temperature drying glue, bonding strength is low, short-term bonding can also, but a long time will be aging, peeling. Some also use epoxy resin adhesive, mostly because the mirror has more defects and used to fill the vacancy. Sometimes mixed with mud, to show the characteristics of unearthed relics. But this kind of bonding often covers the back of the mirror because of the adhesive on the mirror back and the mirror surface, which obscures the whole mirror pattern. If these adhesives are slowly burned (250~300 degrees Celsius) by a slow fire, they become the appearance of figure 1a. 366947-1.jpg The author thinks that the following points should be consistent with the mirror repair re