The Scientist and Engineers Guide to Digital （科学家和工程师的指导数字）.pdf

CHAPTER Moving Average Filters 15 The moving average is the most common filter in DSP, mainly because it is the easiest digital filter to understand and use. In spite of its simplicity, the moving average filter is optimal for a common task: reducing random noise while retaining a sharp step response. This makes it the premier filter for time domain encoded signals. However, the moving average is the worst filter for frequency domain encoded signals, with little ability to separate one band of frequencies from another. Relatives of the moving average filter include the Gaussian, Blackman, and multiple- pass moving average. These have slightly better performance in the frequency domain, at the expense of increased computation time. Implementation by Convolution As the name implies, the moving average filter operates by averaging a number of points from the input signal to produce each point in the output signal. In equation form, this is written: EQUATION 15-1 Equation of the moving average filter. In M 1 this equation, x [ ] is the input signal, y [ ] is y [i ] 1 j x [i %j ] the output signal, and M is the number of M j 0 points used in the moving average. This equation only uses points on one side of the output sample being calculated. Where x [ ] is the input signal, y [ ] is the output signal, and M is the number of points in the average. For example, in a 5 point moving average filter, point 80 in the output signal is given by: x [80] % x [81] % x [82] % x [83] % x [84] y [80] 5