网目电流meshcurrent.pptVIP

* 4.11 More on Deriving a Thévenin Equivalent 求解RTh亦可先將所有獨立電源拿掉（電壓源短路且電流源開路），然後由端點往回看求出等效電阻值。 若電路有相依電源，首先拿走所有獨立電源，然後在a, b 端掛上一個測試用電壓源或電流源，該測試電源之電壓除以電流就是RTh。 EX 4.11 Finding the Thévenin Equivalent Using a  Test Source * vT 為測試電壓源，vT / iT 就是RTh。 * Using the Thévenin Equivalent in the Amplifier Circuit * 4.12 Maximum Power Transfer The derivative is zero and p is maximized when CONDITION FOR MAXIMUM POWER TRANSFER (最大功率轉移時的條件) 最大功率轉移量 EX 4.12 Calculating the Condition for Maximum  Power Transfer * Also, The percentage of the source power delivered to the load is * 4.13 Superposition 重疊原理(superposition)：在線性系統中，將各別獨立電源造成之響應相加，就可以得到總響應。 1) * 4.13 Contd. 2) 將電壓源驅動之電流i’和電流源驅 動之電流i”相加，可得總電流。 v3 v4 EX 4.13 Using Superposition to Solve a Circuit * 1) 2) * * * * * * * * * * * * * * * * * * * * * * * * * * * Chap. 4 Techniques of Circuit Analysis Contents 4.1 Terminology 4.2 Introduction to the Node-Voltage Method 4.3 The Node-Voltage Method and Dependent Sources 4.4 The Node-Voltage Method: Some Special Cases 4.5 Introduction to the Mesh-Current Method 4.6 The Mesh-Current Method and Dependent Sources 4.7 The Mesh-Current Method: Some Special Cases 4.8 The Node-Voltage Method Versus the Mesh-Current Method 4.9 Source Transformations 4.10 Thévenin and Norton Equivalents 4.11 More on Deriving a Thévenin Equivalent 4.12 Maximum Power Transfer 4.13 Superposition Objectives 1. 了解並能夠使用節點電壓法求解電路。 2. 了解並能夠使用網目電流法求解電路。 3. 對於特定電路能夠決定節點電壓法或網目電流法何者是較佳的求解方式。 4. 了解電源轉換，並能夠使用它來求解電路。 5. 了解戴維寧和諾頓等效電路的觀念，並能針對電路建立等效電路。 6. 了解電阻負載最大功率轉移之情況，並能計算滿足此情況之負載電阻值。 * Realistic Resistors * 4.1 Terminology 節點 必要節點 路徑 分支 必要分支 迴路 網目 平面電路 Node Essential node Path Branch Essential branch Loop Mesh Planar circuit A point where two or more circuit elements join A node where three or more circuit elements join A trace of adjoining basic elements with no elements included more than once A path that connects two nodes A path which connects two essential nodes without passing th