WELDING PARAMETERS THICK PLATES AND （厚板和焊接参数）.pdf

FRITZ LABORATORY REPRINT No. 71·29 S.5 J 1...,/ WELDING PARAMETERS THICK PLATES AND COLUMN STRENGTH by J. Brozzetti G. A. Alpsten L. Tall Reprinted from the WELDING JOURNAL, Vol. 50, August 1971 published by the American Welding Society, New York, New York Welding Parameters, Thick Plates, and Column Strength The influence of different welding parameters on the strength of awelded column is studied BY J.-BROZZETTI, G. A. ALPSTEN, AND L. TALL ABSTRACT. This paper presents a study of the effect of the different welding param- of flame-cut plates; annealed shapes indi- the influence of different welding param- eters on the strength of the column. cate the most favorable column strength. eters on the magnitude and distribu- The variation of the mechanical prop- tion of residual stresses in oxygen--or erties through the thickness and at dif- Introduction flame-cut plates 24 X 2 in. made of A36 ferent locations across the 24 X 2 in. steel. The residual stress diagrams ob- plates was determined by means of ten- Thermal stresses due to different tained after complete sectioning and after sion tests on the small size specimens. sources of heat have been investigated slicing are related to the original condi- The results are discussed with respect to both analytically and experimentally tions of manufacture and fabri