分析家用空调器的故障（Analyze the faults of the household air conditioner）.docVIP

分析家用空调器的故障（Analyze the faults of the household air conditioner） Analyze the faults of the household air conditioner Refrigeration system fault analysis 1. check the suction / exhaust pressure of the compressor. The suction / exhaust pressure in the normal operation of the air conditioning refrigeration system should be less than the range given in Table 1, which is not normal if it is greater than the pressure value given in table 1. When the ambient temperature is higher than the maximum value given in Table 1, the system pressure will rise, which can not be considered as a failure of the refrigeration system. But in the ultra high temperature environment, the air conditioner is in overload operation, also easy to cause the protection circuit movement, causes the air conditioner to stop automatically. The exhaust (condensing) pressure in Table 1 relates to the temperature of the cooling medium. When the cooling medium temperature is high, the condensing pressure and condensing temperature increase accordingly. Therefore, the limit values of the condensing pressure and temperature of the cooling medium under normal conditions are given in the table. If beyond the scope of the table, the system is not running properly, should find the reason. 2. observe the condensation and temperature of the suction / exhaust pipe of the compressor. The condensation tube of the compressor suction inlet pipe, pump shell and the pump shell body cold heat, the exhaust temperature is slightly higher, the refrigerant is moderate; no dew tube compressor suction, exhaust temperature is not too hot, indicating less refrigerant. But with the expansion valve, should check whether the valve is too small; compressor suction tube condensation, and more than half of the pump casing are condensation, the amount of refrigerant is too much. If the expansion valve is used, it can also be caused by the excessive opening of the valve. For rotary compressors, when normal, the pump housing is high temper