ex10-2（ex10 - 2）.doc

ex10-2（ex10 - 2） /filename, ex6-4 set name! /title, The Dynamic Analysis of the Dam set the title! The /prep7 module into the top! *set, h, 150! Define the parameter variables, dam height Et, 1, plane42 set the unit type! The definition of material parameters! Mp, ex, 1,2.9e10 135m the following concrete material parameters set! Mp, prxy, 1,0.17 Mp, dens, 12500 Mp, ex, 2,2.5e10! 135m set above material parameters of concrete Mp, prxy, 2,0.17 Mp, dens, 22500 Mp, ex, 3,2.9e10 set the material parameters of rock! Mp, prxy, 3,0.3 Mp, dens, 32600 Create a key point! K, 1, K, 2,0.9*0.7*h+0.1*h K, 3,0.1*h, 0.9*h K, 4, 0.9*h Create a line! L, 1,2 L, 2,3 L, 3,4 L, 4,1 Create face! Al, 1,2,3,4 Rectng, 0,0.1*h, 0.9*h, H Create! At the dam heel point and surface K, 9, 0.2*h K, 10, -0.1*h A, 1,9,10 Create! And key points for the rest K, 11, -1.5*h K, 12, -1.5*h, -2*h K, 13,0.9*0.7*h+2.1*h, -2*h K, 14,0.9*0.7*h+2.1*h A, 11,12,13,14 K, 15, -0.1*h, -2*h K, 16, -2*h K, 17,0.9*0.7*h+0.1*h, -2*h A, 1,10,15,16 A, 16,17,2,1 Aplot Aovlap, all Aglue, all /pnum, area, 1 /pnum, line, 1 NUMMRG, ALL, all combined with repetitive elements! NUMCMP, ALL! All compression number APLOT Across the grid! Lsel, s, and 15,16,1. Lsel, a, 3,4,1,! Across the 4 mesh corresponding to the top of the dam Lesize, all, 10, set the line segmentation number is 10! Mat, 2 Amesh, 4 ! Lsel, s, 1, 7! Across the mesh corresponds to the lower dam Lesize, all, 10. Lsel, s, 2. Lesize, all, 30. Allsel Lsel, s, 5,21,16, 5 and 21 at the line! Are two separate segments Lccat, all! On line 5, 21 connected operation, to meet the conditions of Grid Mapping Division Mat, 1 active material number 1! MSHAPE, 0,2D! Set grid shape for 2D quadrilateral mesh MSHKEY, 1! Set of mesh for mesh mapping Amesh, 7 Ldele, 22! Delete connection line 22, 22 is 5 and 22 connection line Amesh, 1! Opposite 1 grids, corresponding to the dam heel section Allsel Lsel, s, 8,14,2,! Across the 2 mesh corresponding to the lower part of the dam bedrock Lse