三洋投影仪（SANYO projector）.docVIP

三洋投影仪（SANYO projector） Fault: projector in VCD, video Showcase Video signal to normal projection, but in the switch to the RGB signal when the computer boot, DOS display under and after entering the Windows to normal projection The reason: the computer refresh rate is too high or adjust the resolution of computer control is too high, beyond the normal working range of the projector, the projector of the possibility of purchase in the two or three years before the performance index is low on the larger. Solution: the computer refresh rate to below 75Hz, the computer will lower resolution, the best can make the projector work at its maximum physical output resolution (the ratio of maximum input low resolution level), the best display at this time. Fault two: projector without the use of a period of time automatically shut down, after a few minutes to boot, this fault occurs repeatedly 1 reasons: poor ventilation caused by internal cooling bad start internal thermal protection circuit. Solution 1: air inlet filter cleaning of the projector, the projector to ensure access to air unobstructed, regular filter on the projector for cleaning, and keep the environment clean the projector. 2 reasons: the high temperature caused by internal thermal protection circuit start. Solution 2: in the classroom in the installation of air conditioning, fan projection equipment such as cooling, heat dissipation, such as projector ceiling installation is to ensure that the upper space of the projection classroom can also the normal temperature. 3: power supply board device. Solution 3: maintenance or replacement of the power supply board. Fault three: blurred projection 1 reasons: the focus of the projector is not adjusted. Solution 1: focus on the remote control or manual adjustment of the projector. 2 reasons: the projector lens or filter dust too much. Solution 2: clean the projector lens, filter, professional treatment of dust inside the projector. 3 reasons: the projector resolution i